WindCalculations ASCE Wind Pressure Reference Calculator
WindCalculations.com logo

ASCE Wind Pressure Reference Calculator

Public ASCE 7-16 / 7-22 reference calculator for velocity pressure and low-rise C&C (h ≤ 60 ft) net pressure screening using a transparent, browser-only workflow. Validated against third party software for Exposure C reference cases.

Embedded mode is active. This compact layout is optimized for iframe usage.

Inputs

All calculations run in your browser. No backend calls are used.

Code Edition and Site Parameters

7-16 places Kd inside qz. 7-22 takes Kd out of qz and applies it in the pressure equation. Net pressures are equivalent.

Select V from the wind speed map for your Risk Category. No separate importance factor is applied.

3-second gust at 33 ft in Exposure C (ASCE 7 Section 26.5).

Low-rise C&C provisions (Ch. 30 Figs. 30.3-x) apply when h ≤ 60 ft.

qz shown for MWFRS reference only. C&C net pressure uses qh at mean roof height h.

Factors and Pressure Coefficients

Default 1.00 (flat terrain). See Section 26.8 for hills/escarpments.

Default 1.00. ASCE 7-22 permits Ke=1.0 at all elevations; less than 1.0 only at high elevations per Table 26.9-1.

Kd = 0.85 for buildings per Table 26.6-1.

When θ ≤ 10°, ASCE Fig. 30.3-1 footnote permits wall GCp values (Zones 4 & 5) to be reduced by 10%.

Preset values are base values from ASCE Figs. 30.3-1 / 30.3-2A at the effective wind area noted. Verify against the applicable figure for your zone and area.

Base value. 10% wall reduction applied separately if checkbox above is on and θ ≤ 10°.

Per Table 26.13-1.

Method: Edition-aware low-rise C&C calculation. The gust effect is already combined into GCp and GCpi—no separate G factor is applied. qz is shown for MWFRS reference and is not used in the net C&C pressure. Rooftop equipment force design (Ch. 29) is not included.

Embed Snippet

Use this iframe code to embed the calculator on another page.

Results

No calculation yet

Fill in the form and select Calculate Wind Pressures.

Methodology and References

Core wind equations are implemented in-browser for transparency and review. ASCE 7-22 Eq. 26.10-1 for velocity pressure (Kd excluded from qz); Ch. 30 Eq. 30.3-1 for low-rise C&C net pressure (Kd applied in pressure equation). ASCE 7-16 follows the prior form with Kd inside qz.

Applicable scope: Low-rise enclosed / partially enclosed / partially open / open buildings with h ≤ 60 ft. GCp values from Ch. 30 Figures 30.3-1 (walls) and 30.3-2A–D (roofs) depend on effective wind area and zone. Users must verify the applicable figure, zone, and effective wind area for their project.
Important Disclaimer
  • This calculator is for informational and preliminary screening use only.
  • Use does not create an engineer-client relationship or professional engineering service agreement.
  • Results depend on user-selected coefficients and assumptions and are not a substitute for project-specific code analysis.
  • Users are responsible for confirming adopted code edition, jurisdictional amendments, and governing load cases.
  • Final design and permit decisions must be reviewed and approved by a licensed professional engineer.
  • WindCalculations.com disclaims liability for losses arising from use or misuse of this tool.
Need stamped design support? Request a professional review at windcalculations.com.